This Battery Electrical System Analyser can be connected to a mini printer(optional).
It has 4 Tests in 1 tool.
1. Battery Test
2. Grounding Test
3. Starter Test
4. Alternator Test
It has a built-in memory to store the last tested results for later viewing.
Application: This Battery Electrical System Analyser (BESA V3) is a new way of measuring the Cold Cranking Amps (CCA) of a car battery and it test a wide variety of 12V batteries: Wet (Flooded), VRLA or Maintenance Free (MF), Sealed Maintenance Free (SMF), Absorption Glass Mat (AGM) and GEL cell.
In addtion, it tests the car battery electrical system: grounding contact, starter and alternator conditions.
New Technology: This Analyzer uses a unique electrical measurement called the conductivity method that determines the ability of a battery to transmit current through its internal structure. Conductivity is measured by probing the battery with a small AC current ripple that generates a small AC voltage response. And is the relative ratio of the variation in current with the variation in voltage. By using this method to test and analyze the conditions of the 12V battery means the battery can be tested and analyze whether it is on or off the vehicle.
This Battery Electrical System Analyzer (BESA) is designed to perform the following tasks:
1. Battery Test: a. Test results on battery conditions : Either Good or Replace b. Battery state of charge: Digital display in Volts. c. Key in actual battery rating (CCA, DIN, EN, IEC, JIS) before test for better accuracy. d. Battery cell resistance measurement : Display in m ohm e. Battery Life Expectancy: Display in percentage (%).
2. Grounding Test : Quick and Easy checking of engine and chassis ground with display of results and recommendations after test.
3. Starter Test: a. Quick and Easy cranking test to determine the battery cranking power and results will be displayed after test. b. From the test results given, you can determine whether the battery has aged, bad connections or starter problems.
4. Alternator Test: a. Check the charging conditions of the alternator during electrical loading @ 2,000 rpm and without electrical load @ 3,000 rpm. with results and recommendations display after test.
Advantages: 1. Intelligent > It detects and removes surface charge if any, before proceeding to perform tests for better results. 2. Accurate > Consistent and accurate test results 3. Fast > It takes less than 3 seconds to obtain not only the values but result summary 4. Direct > Testing is done on the battery whether it is on or off the vehicle. Also able to test discharged or weak batteries. 5. Safe> It does not create spark during clamping or wrong connection to the battery while performing tests. 6. Maintenance Free > No internal batteries required. It powers up when connected to the battery posts during testing. And it never discharges or drain the battery.
User Friendly: The operation is fast and simple. When hooked up to the battery posts, the displayed instructions on the screen will lead you through to perform the correct steps. In the event that you need assistance, the "HELP" key will display information about each function when selected.