Application: 12V, Starting Battery
Rating: CCA(SAE), DIN, JIS, IEC, EN
No of Tests:
1. Battery Test (Good/Recharge/Replace, Volt, CCA, mOhm, Life%)
2. Starter Test
Language: English (or any 1 language per Analyser)
Packaging: PP BOX
State of charge (SOC), or conversely, the depth of discharge (DOD) can be determined by measuring the voltage using a volt meter and/or the specific gravity of the acid with a hydrometer. However, this will NOT tell you how good the battery condition is - only a sustained Load Test can do that.
This Battery Performance Analyser (BPA-11) not only tests the battery's current voltage and power, it comes with voltage drop test during cranking the engine to determine whether the battery has aged.
It's a new and correct way of measuring the Cold Cranking Amps (CCA) of a Starting Battery and it test a wide variety of 12V batteries: Wet (Flooded), VRLA or Maintenance Free (MF), Sealed Maintenance Free (SMF), Absorption Glass Mat (AGM) and GEL cell.
New Technology: This Analyzer uses the battery internal resistance gathered during testing to compute the final results of the battery condition. This process involve by a series of shorting pulse across the battery terminals with resulting drop in the voltage being measured by the microprocessors to compute its final results.
A. Battery Condition Test shows results: a. Test results on battery conditions : Either Good or Replace b. Battery state of charge: Digital display in Volts. c. Available Battery Power in CCA, SAE, DIN, EN, IEC or JIS d. Battery cell resistance measurement :Display in m ohm e. Battery Life Expectancy: Display in percentage (%).
B. Voltage Drop Test: to observe the behavior and determine the health of the battery while cranking the engine.These tests are conducted by its built in microprocessor using the latest battery testing technology which will not harm the battery and its results are fast, consistent and accurate.
It tests all types of 12 volts automotive batteries ranging from WET, MF, CMF, AGM and Gel Cell types.
- Intelligent Able to detect and remove surface charge if any, before commencing test for better results. - Accurate Consistent and accurate test results. - Fast Takes less than 5 seconds to compute the results. - Direct Test can be done on or off the car. Also can test on weak or discharged batteries. - Safe Does not create sparks during clamping and wrong polarity protected during testing. - Maintenance Free No internal batteries required.
User Friendly: The operation is fast and simple. When hooked up to the battery posts, the displayed instructions on the screen will lead you through to perform the correct steps. In the event that you need assistance, the "HELP" key will display information about each function when selected.
Operating Voltage:9~15 Volts
Testing Capacity:CCA100 ~ 1700 Amps
IEC100 ~ 1000 Amps
JIS#100 ~ 1700 Amps
DIN100 ~ 1000 Amps
EN100 ~ 1700 Amps
Analysing Time:Less than 5 Seconds.
Users Friendly (Step by step instruction on operation)